Digimerge DH100 Series Manuál s instrukcemi Strana 128

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 140
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 127
116
Appendix J: Replacing the Hard Drive
APPENDIX J: REPLACING THE HARD DRIVE
The system comes with a pre-installed 3.5" SATA hard drive. You can install up to one 1.5TB hard
drive.
NOTE: Mak
e sure that the system is
OFF
and the power cable has been disconnected before
changing the hard drive.
Removing the Hard Drive
To remove the hard drive:
1. Power off the system, and unplug all wiring / cabling from the system.
2. Remove the two (2) short screws on the side panels
of the housing and the three (3) short
screws on the rear panel. Keep these sets of screws separate.
*8-channel model shown
Zobrazit stránku 127
1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 139 140

Komentáře k této Příručce

Žádné komentáře